Now, we need to figure out the device vendor number and product number to tell the usbserial driver. Usb 1-1: configuration #1 chosen from 1 choice Usb 1-1: new full speed USB device using uhci_and address 2 Torward the end of the messages, you should see this: After plugging in the device, first check the hardware messages to see the device was detected: If you are using the usb -> RS232 adapter, the serial drivers may need to be installed for the device to work properly. ![]() ![]() The procedure for using the USB adapter from the BOM wasn't in the wiki - nor was it immediately obvious, so, here goes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |